Toymods Car Club Inc: Tech & Conversions => 2S-C Head Torque Settings

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » 2S-C Head Torque Settings Show: Today's Posts :: Show Polls Email to friend

Author

Topic

ZZT231
Forums Junkie

I Supported Toymods

Location:
melbourne.vic.au
Registered:
May 2002

2S-C Head Torque Settings	Fri, 06 August 2004 03:54

Hey All, I think its time to tighten the headgasket on my 2S-C. Does anyone know the torque settings and the sequence to do it? Cheers. [Report message to a moderator]

jackel
Forums Junkie

Location:
Perth
Registered:
August 2003

Re: 2S-C Head Torque Settings	Fri, 06 August 2004 06:08

cylinder head bolts 64Nm camshaft housing tightening sequence 6-----4-----1------7 \|-------------------\| \|-------------------\| \|-------------------\| 8-----2-----3------5 hope that helps [Report message to a moderator]

CLG
Forums Junkie

I supported Toymods

Location:
Perth, Western Australia
Registered:
December 2002

Re: 2S-C Head Torque Settings	Fri, 06 August 2004 06:16

While we're on the subject of 2S-C motors, can anyone tell me if they are an interference style setup, or not? I'd like to know if I can expect bent valves and all the other associated dramas that come from a broken timing belt in this type of motor? Clint [Report message to a moderator]

jackel
Forums Junkie

Location:
Perth
Registered:
August 2003

Re: 2S-C Head Torque Settings	Fri, 06 August 2004 06:34

just reading from the book here it says when checking timing belt check the values as damage could of accured [Report message to a moderator]

Norbie
Forums Junkie

Location:
Brisbane
Registered:
May 2002

Re: 2S-C Head Torque Settings	Sat, 07 August 2004 01:06

All Toyota engines with timing belts are non-interference. [Report message to a moderator]

Previous Topic:	jza70 supra/cressida compatibilty?
Next Topic:	MA70 problems...

Current Time: Fri May 3 17:21:46 UTC 2024

Total time taken to generate the page: 0.0039451122283936 seconds

.:: Contact :: Home ::.