Toymods Car Club Inc: Tech & Conversions => 2t/3tg rebuild, power output question

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » 2t/3tg rebuild, power output question Show: Today's Posts :: Show Polls Email to friend

Author

Topic

juzzo84
Forums Junkie

Location:
Hornsby, N.S.W
Registered:
September 2002

2t/3tg rebuild, power output question	Thu, 07 August 2003 12:31

heya guys, i know there are a few guys out there running the same setup and was just wondering what sort of power figures you were getting???? the layout is injection: 2tgeu standard efi plenum with 3sge (2litre) injectors running with a microtech digi 1 computer. ignition: the car is running electronic ignition (no points) with 8mm spark leads and NGK platinum plugs. 88260 head, skimed, valves re-seated, new springs, machined and leak tested (no leaks), mild cams (clearances set at 10 and 10) the bottom end has been decked, honed, bored (20 thou oversize), t6 light alloy pistons, new rings, acl bearing, crank shaft has been machined and polished, lightened flywheel, everything has been fully balanced! is there anyone with a similar setup that may be able to tell me what sort of power to expect???? im assuming around the 70kw's at the rear wheels, is this unreasonable with the computer well tuned???? thanks justin [Report message to a moderator]

Current Time: Sat Jun 28 12:57:03 UTC 2025

Total time taken to generate the page: 0.0073812007904053 seconds

.:: Contact :: Home ::.