| Author | Topic |
|---|
I supported Toymods
Location:
Epping, Sydney
Registered:
May 2002
|
|
1jz coil packs and holders
|
Thu, 16 October 2003 13:45
|
 |
Ive just pulled the coil packs on my 1jz - figure Ill pretty much rebuild the entire engine while its out
now apart from replacing all the screws that hold the coil packs to the brackets (2 of which burred and I need to drill out), what else should I do?
the brackets themselves are looking a little off, and one of them is slightly rusted. Im considering sanding them back, and was wondering if theres some sort of protective coat I could put on to stop corrosion/rust (also, what are they made of? steel?)
I think a simple clear lacquer coat wouldnt stand up to the temps, being right on top of the engine
any advice?
|
|
|
