| Author | Topic |
|---|
Location:
Adelaide
Registered:
May 2003
|
|
4AGE Compession Ratio Calculations
|
Mon, 03 May 2004 02:26
|
 |
Right, ive been trying to figure out how much ill have to either shave off my head or remove from the HG in order to garner a 11.5:1 ish CR on my smallport 4A.
What i need is a few figures.
Firstly, how thick is the stock 4A HG when compressed? So if someone has recently replaced one and hasnt thrown out the old one can you just measure it up for me.
Secondly, what is the dish capacity on the stock pistons?
Finally, what is the head capacity?
If anyone can easily tell me how to achieve 11.5:1 CR and has already done this then please speak up too.
Oh yeah, and i found this HG from HKS (HKS Head Gasket Stopper Type. 0.6 mm. 82.5 mm bore. 11.6 compression ratio.) which claims an appropriate CR. Is this right, cos it looks a bit over the top for that CR.
CHeers
|
|
|
| | Subject | Poster | Date |
|---|
 |
4AGE Compession Ratio Calculations
|
takai | Mon, 03 May 2004 02:26 |
