| Author | Topic |
|---|
I supported Toymods
Location:
Epping, Sydney
Registered:
May 2002
|
|
how to cut a 3mm deep 1.5mm wide channel in rubber?
|
Mon, 03 May 2004 04:13
|
 |
to finish my radiator, I need to cut a channel of the above dimensions in some 6mm thick rubber.
Ideally I'd use a router I guess, but I dont have one. I'm considering tracing the channel with a knife, then following the line with a drill - but as it's so narrow and the rubber is fairly firm, I'm worried about breaking the drill bit (and I've broken a few drill bits in my time attempting to use them as router pieces)
any other ideas?
|
|
|
| | Subject | Poster | Date |
|---|
 |
how to cut a 3mm deep 1.5mm wide channel in rubber?
|
draven | Mon, 03 May 2004 04:13 |
|
Re: how to cut a 3mm deep 1.5mm wide channel in rubber?
|
Jason | Mon, 03 May 2004 04:18 |
|
Re: how to cut a 3mm deep 1.5mm wide channel in rubber?
|
draven | Mon, 03 May 2004 06:58 |
|
Re: how to cut a 3mm deep 1.5mm wide channel in rubber?
|
munki | Mon, 03 May 2004 04:49 |
|
Re: how to cut a 3mm deep 1.5mm wide channel in rubber?
|
Ben Wilson | Mon, 03 May 2004 05:19 |
|
Re: how to cut a 3mm deep 1.5mm wide channel in rubber?
|
YelloRolla | Mon, 03 May 2004 07:02 |
|
Re: how to cut a 3mm deep 1.5mm wide channel in rubber?
|
draven | Mon, 03 May 2004 07:48 |
|
Re: how to cut a 3mm deep 1.5mm wide channel in rubber?
|
YelloRolla | Mon, 03 May 2004 07:50 |
|
Re: how to cut a 3mm deep 1.5mm wide channel in rubber?
|
ChuckLandwehr | Mon, 03 May 2004 10:14 |
|
Re: how to cut a 3mm deep 1.5mm wide channel in rubber?
|
draven | Mon, 03 May 2004 10:22 |
|
Re: how to cut a 3mm deep 1.5mm wide channel in rubber?
|
kaos | Mon, 03 May 2004 11:36 |
