Toymods Car Club Inc: Tech & Conversions => BOV on 1GGTE

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » BOV on 1GGTE Show: Today's Posts :: Show Polls Email to friend

Author

Topic

MR 1JZ
Forums Junkie

I supported Toymods

Location:
Adelaide
Registered:
July 2004

BOV on 1GGTE	Sun, 11 July 2004 03:59

Hey all I just picked up a monza type 2 BOV for 40 bucks on EBAY brand spankers. I wanna slap it on the stock cooler pipe, on the side that is closest to throttle body by drilling into the stock rubber piping, is this possible, if not then what is a relatively cheap alternative to the situation? [Report message to a moderator]

Subject Poster Date

Read Message BOV on 1GGTE MR 1JZ Sun, 11 July 2004 03:59
Re: BOV on 1GGTE EvilJack Sun, 11 July 2004 04:42
Re: BOV on 1GGTE MR 1JZ Sun, 11 July 2004 10:33
Re: BOV on 1GGTE indian Sun, 11 July 2004 23:11
Re: BOV on 1GGTE MR 1JZ Sun, 11 July 2004 23:16
Re: BOV on 1GGTE indian Sun, 11 July 2004 23:38
Read Message Re: BOV on 1GGTE MR 1JZ Mon, 12 July 2004 00:41
Re: BOV on 1GGTE indian Mon, 12 July 2004 00:48
Re: BOV on 1GGTE MR 1JZ Mon, 12 July 2004 01:08
Re: BOV on 1GGTE indian Mon, 12 July 2004 01:10
Re: BOV on 1GGTE Bugman Mon, 12 July 2004 07:46
Re: BOV on 1GGTE MR 1JZ Mon, 12 July 2004 22:50

Previous Topic: will these wheels fit?
Next Topic: ZE PCV system

Current Time: Sun Jul 27 08:46:20 UTC 2025

Total time taken to generate the page: 0.0046169757843018 seconds

.:: Contact :: Home ::.