| Author | Topic |
|---|
Location:
Arthurs Creek, Victoria
Registered:
May 2002
|
|
HELP! I put the rear main seal in skew!
|
Thu, 31 October 2002 02:16
|
 |
I've put the rear main seal in the 1g and one bit slipped in pretty well, so I put the other bit in, and then found that the other edge is in further than the one I was pushing in! Is this a probleM? I can't get it out without destroying it, and with a few turns of the crank it seemed to be moving back to it's original position, but I'm not sure whether it really will move back to where it should or not! Will this be a problem!? It still seems to seal.
|
|
|
