I'm putting a full T-18 driveline into a AE71 and i was wondering if the AE71 X-member will be fine for the T-18 T50 (i assume so) as well as whether or not i can use the whole T-18 Tail shaft
I think it should be fine if i use the T-18 Tail shaft with the AE71 GB X-member, but i could be wrong (up until i checked 10 mins ago i thought the T-18 GB xmember was a straight bolt in too )
Also, the motor will be T series. Ive seen karl skew's article where he used A series mounts and a 10mm spacer on one side of the engine to put a 3TC into his AA60 so i was thinking something similar, otherwise i might have to try my hands at fabricating engine mounts. I don't want to swap cross members as i want to keep it intact for a possible later more 4a like conversion
Fri, 04 February 2005 21:09
)
