Kit of parts Nissan rotor/Magna caliper suit RA23/28 size hubs
Fri, 17 June 2005 03:37
Hi All,
I am developing another kit of parts to do a Nissan/Magna brake set-up.
Similar to what Jack is now running in his 3S-G TA-22 and I have mentioned about in another thread.
Pic of rotors on hubs as a starter below.
I have most of the work done and it will be available as a bolt on swap of hubs.
Depending on the original model Celica I'll supply all the parts including Master Cylinder and rear slave cylinders to get the brake balance close to right.
Cost will reflect the cost of the machining needed to make the rotor/adaptor and fabrication of the caliper bracket. This has been done at commercial rates (no mates rates unfortunately).
All up $1300. If the 80 Series Landcruiser caliper fits then $1500.
Fri, 17 June 2005 03:37
