hey guys i snapped an axle in my te71 on the weekend and after going to put a new one in my spares are different. the diff in the te71 is a jap T series disk brake diff and the diff ive gotten my spare axles from is an aus t18 T series.
now to start the bearings arent as wide on the t18 axles. the te71 bearins are 45mm thick and the t18 ones are only 17mm thick.
then theres the plates that hold the axle in the diff. they have a much different arrangement of holes for the bolts to go into. on the t18 ones the bolts are equall on 2 sides each (like a rectangle) but on the te71 diff the holes are only equal on the left and right sides. the top and bottom are un even.
also both sets of bearings are 72.1mm but the t18 ones dont fit snugly in the diff for some reason. is the bearing seat tapered in the diff or something and so not letting the shorter bearing go all the way in?
please help with this guys cause im real confuzled. i thought they would be the same because i doubt the te71 diff is a later model ae86 diff. it could be possible but cause when i went to put a new tailshaft in i found that i had a ae86 t50 gearbox with the bigger output shaft than the te71/72 t50. so maybe the guy before me put a kouki in.
i have posted some piks so you guys know understamd my babbling.
if someone has an axle that will fit my diff requirements please let me know. im very desperate to get it back on the road now after some encouraging words from jesse. haha cheers jesse.
Wed, 27 July 2005 11:45
