| Author | Topic |
|---|
Location:
Melb
Registered:
August 2005
|
 Reversing control arms? need Help do or don't
|
Wed, 24 August 2005 14:58
|
 |
Im putting RA65 struts in a KE55
I have positive camber and a quick fix could be to revers the set up of the arms and switch them onto the oposite control arm..
giving me 1cm+ difference.
if i can do this i may look at getting the RA65 balljoints into the MX73 lower cont arm to give me 1cm more. coz they are longer then the RA65.
ive got many parts been stuffing around .. RA40 RA65 MX73 & KE55 all control arms pairs.
2nd Question is i have cressida MX73 "with only 1 strut bottom" control arms too these Fit on the struts bolt pattern but are not as wide at the bottom of the strut unlike the RA65.. using this setup i gained 2cm measured from the bolt on strut to the cross member where the arm meets the body of the car..
any one done this or head of it does it matter that its not perfect fit i could seal it with silicon  to stop dust or a little dirt getting in there..
if i do this i will need new ti-rods too i think.. could drill one side out a bit to make it fit maybe?
3rd i could get Sigma one but dont know what to do? grind the crush tube ive heard.
Ta,,
any one got some help it will be appreciated..
|
|
|
