| Author | Topic |
|---|
Location:
NSW
Registered:
March 2005
|
|
4AGZE INTO RWD SPRINTER
|
Mon, 28 November 2005 00:32
|
 |
Quick question. I am putting a 4agze into my ae86 using the same t50 gearbox. I am going to put a decent clutch in while it is all apart but just unsure which one to order. Im pretty sure it is the clutch to suit the 4agze. Is this correct?
Thanks./.
|
|
|
Location:
Canberra
Registered:
September 2005
|
|
Re: 4AGZE INTO RWD SPRINTER
|
Mon, 28 November 2005 00:52
|
|
You'll need a 20v or 16v 4AGE flywheel and clutch to fit in a t-50
bellhousing!
4AGZE setup to big for t-50 bellhousing with out some modification
|
|
|
Toymods Social Secretary
Location:
Sydney
Registered:
July 2002
|
|
Re: 4AGZE INTO RWD SPRINTER
|
Mon, 28 November 2005 01:30
|
|
on top of that, the 4agze E58 gearbox (fwd) uses the bigger input shaft spline the same as the W50, W58 etc rwd boxes..... thus a 4agze clutch disc would be completely useless with a T50 gearbox.
Do as the person above suggests.... and be careful with that glass cased box there!
|
|
|
Location:
Melbourne
Registered:
May 2005
|
|
Re: 4AGZE INTO RWD SPRINTER
|
Mon, 28 November 2005 08:10
|
|
|
So if you use a W5X gearbox with a custom bellhousing you can keep the std flywheel and clutch?
|
|
|
Toymods Social Secretary
Location:
Sydney
Registered:
July 2002
|
|
Re: 4AGZE INTO RWD SPRINTER
|
Mon, 28 November 2005 08:20
|
|
yes you can keep the gze flywheel and clutch.
although its about a $1000 exercise 
|
|
|
Location:
Montrose, VIC
Registered:
May 2002
|
|
Re: 4AGZE INTO RWD SPRINTER
|
Mon, 28 November 2005 12:05
|
|
...but then think of how much better it is to do that than spend 3 times that much replacing T50s 
|
|
|
Location:
NSW
Registered:
March 2005
|
|
Re: 4AGZE INTO RWD SPRINTER
|
Mon, 28 November 2005 20:56
|
|
Ok so to cut a long story short I need a 4age clutch. I allready have one and also the flywheel but need a new one as my clutch is rooted. The 4agze clutch is 20mm larger in diametre if I remember correctly.
So I will be fine if I go and purchase a RWD 4age clutch? :)
|
|
|
Location:
Canberra
Registered:
September 2005
|
|
Re: 4AGZE INTO RWD SPRINTER
|
Mon, 28 November 2005 21:43
|
|
Any 20v or 16v rwd or fwd setup , just not a gze setup.
But as mentioned above $1000 aprrox versus replacing a blown t-50
when its had enough, because your running a 4AGZE you'll have problems with the t-50, but you could always see how you go with the t-50, it just wont put up with a lot of stick.
|
|
|
