Toymods Car Club Inc: Tech & Conversions => 1JZ Wiring Diagrams for JZX-90 Chaser

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » 1JZ Wiring Diagrams for JZX-90 Chaser Show: Today's Posts :: Show Polls Email to friend

Author

Topic

1JZ.747
Forums Junkie

Location:
Osama's hideout
Registered:
February 2003

Re: 1JZ Wiring Diagrams for JZX-90 Chaser	Fri, 02 May 2003 05:24

millhouse none i stripped everything seats forward out of my mx83 and bolted everything in out of the half cut clipped the rear harness to the chaser front harness turned the key and it all worked. i suggest against doing it though as the speedo is very difficult to read as the numbers roll over so quick, took a long time to get used to it. MX73ij the pipes didnt give me a boost spike, that is a load of crap. i use a $65 air pressure regulator, never get spike and it hits full boost straight up every time. i had a 2 stage turbo smart, it was crap, then a DNA which was abit better, go into a hardware store that sells air pressure regulators, have a look at my engine bay in the Nats photo's and you will see the regulator i am talking about in the left side of photo behind the fan oil bottle. [Report message to a moderator]

Current Time: Tue Aug 26 12:01:25 UTC 2025

Total time taken to generate the page: 0.0046329498291016 seconds

.:: Contact :: Home ::.