| Author | Topic |
|---|
I supported Toymods
Location:
I renounced punctuation
Registered:
May 2002
|
|
Re: 1jzge NA camshafts into a 1jzgte engine question
|
Fri, 09 May 2003 05:18
 
|
 |
I'd be interested to hear if there is much of a difference in lift. Have you measured this with a dial indicator?
I can measure the 2JZGE cam seals for you tomorrow. I have a couple lying around. 
Are you sure the 1JZGE intake cam actually has a tooth at all? The 2JZGE has no cam angle sensor, and the intake cam has no reference tooth at all. All the crank and cam angle sensing is done via the distributor in the 2JZGE, and funnily enough on one of my motors the dizzy is labelled as a 1JZGE, so I'd have assumed it was the same.
I'll post up the cam seal dimensions tomorrow.
|
|
|
