You can fit the sc14 onto a gze. All that is required is modifying the bottom mount and fabricating a top mount.
Having said this, without some sheetmetal mods to the rear firewall you'd be hard pressed to get the sc14 in a mr2. Due to its size it sits out quite a bit further from the block.
I'm running this setup on my ae86 with a standard gze computer (far from optimal) and it gets 9psi from 2000rpm building to 11-12 which it will hold till redline. The bigger sc also allows the gze to be revved without tapering off as bad.
And no the pulleys are not interchangeable. It may be possible to make the sc12 pulley fit onto an sc14 with some form of custom spacer.
Are you sure its a custom pulley on the s/c. The more common method is to fit a larger crank pulley (i.e. Nevo). There were custom clutch pulley setups for the s/c available in Japan but they were prohibitively expensive.
Mon, 12 May 2003 05:55
