| Author | Topic |
|---|
Toymods Board Member
Location:
Sydney
Registered:
May 2002
|
|
Re: Aussie Exhausts Dump pipe + connector pipe - info ?
|
Wed, 28 May 2003 03:05
|
 |
you can have a specialist exhaust place custom make a dump-pipe... but finding someone to do it at a reasonable price will be hard
aussie exhausts do some good work but are a little pricey
their ceramic (?) coated dump-pipe is worth getting though (i have one on mine)
the second oxy sensor place is not necessary... it lets you have another sensor for more gadgets... eg. you could wire in an egt gauge probe in that hole etc... unless you specifically need it for something dont bother
ok if your current system is cat-back then to install the dump pipe you will need to remove the cat... to comply with regulations you will need to then install a hi-flow cat into the exhaust
is it 3" already?
ok... if it was me... i'd take off the cat/turbo elbow/exhaust
buy the aussie dump-pipe
install it with a new gasket (it will be a bit of a bitch because its a very tight fit and may require the air-con compressor and alternator to come off - get a shop to do it if you cant be bothered)
take it to your local performance exhaust shop (with the old exhaust if its 3") and get them to make up a 3" mandrel bend system from the dump-pipe back and including a hi-flow cat
(he may be able to use part of the old exhaust if it is 3" and in good condition - this will save you a little cash)
hope this helps
|
|
|
