Toymods Car Club Inc: Tech & Conversions => Superstrut disc straight fit (almost)

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » Superstrut disc straight fit (almost) Show: Today's Posts :: Show Polls Email to friend

Author

Topic

shano2
Regular

Location:
QLD - Sunshine Coast
Registered:
July 2002

Re: Superstrut disc straight fit (almost)	Mon, 16 June 2003 08:22

Firstly the DBA part number is wrong. The only Mazda Astina disc that is 24mm thick (according to the Mazda PDF files I downloaded from the DBA site) is the DBA537. Secondly it is NOT the outer part of the disc you have identified with your arrow that centres and locates the disc, rather it is the centre hole of the disc. The AE92 Corolla uses a 54mm centre hole and the Mazda disc uses a 55mm centre hole - a combination inviting a wheel balance problem IF your method of location doesn't work. Thirdly it's a real pity you wasted so much time sifting through the DBA parts listing because if you had looked around the twincam16 site you also posted this on you'd have found that this swap has been done (several times), and documented (recently - see link below), using (with all due respect) a better selection of parts to suit the conversion, so all of this work has already been done for you . http://pub131.ezboard.com/ffwdtoyotafrm2.showMessa ge?topicID=3369.topic Later Shane [Report message to a moderator]

Current Time: Tue Jul 22 14:26:48 UTC 2025

Total time taken to generate the page: 0.0037400722503662 seconds

.:: Contact :: Home ::.