Toymods Car Club Inc: Tech & Conversions => Superstrut disc straight fit (almost)

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » Superstrut disc straight fit (almost) Show: Today's Posts :: Show Polls Email to friend

Author

Topic

RSSTi
Regular

Location:
Melb, Victoria
Registered:
September 2002

Re: Superstrut disc straight fit (almost)	Mon, 16 June 2003 23:08

Firstly my apologies, the DBA part number is DBA537. Secondly the outer part of the flange that i have arrowed is the part that requires machining to fit the disc, seeing that the center hole of the disc is 55mm and the corolla hub is 54mm i've used the flange to center the disc as long as it has been macined properly so there is no need to machine the center hole of the disc and make a locater. Thirdly it's a real pity that you can't accept that someone has tried a different method to your own and has been successful. I've read your post and others on the subject and then decided there must be an easier way to do the conversion rather than drilling and machining the disc to suit. I've also spoken to brake specialist and an engineer who didn't like the idea turning a 5 stud disc into swiss cheese with 9 holes weakning the surface. So i've satisfied my engineer and i can use a disc that is easily replaced at $100 per side and no need for machining Vic. [Report message to a moderator]

Current Time: Sat Jul 26 04:11:56 UTC 2025

Total time taken to generate the page: 0.0049979686737061 seconds

.:: Contact :: Home ::.