Location: Barossa valley SA
Registered: January 2003
Re: 7M-GTE Air Flow Meter
Sun, 22 June 2003 01:29
As I said in the other thread, I made one out of stainless steel. I just went down to the local metal supplier and got them to cut me a flat piece the right size for the AFM and a few cm of 3" pipe. I took that to the guy that did my exaust and got him to tack weld the two pieces together (it would distort if mig welded completely) then went home, cut out the flat material in the middle and drilled holes for the bolts. I used a bit of silicone to make it airtight around the tack welds and made a gasket out of old inner tube.
Sun, 22 June 2003 01:29
