| Author | Topic |
|---|
Location:
newcastle
Registered:
May 2002
|
|
Re: HELP Distributor drive in backwards need ignition
|
Wed, 03 July 2002 13:47
 
|
 |
its only an 18rg so if u remove the rocker cover, dump oil,drop sump onto cross member remove timing case studs under head,(this is best done by useing the 2 nuts one nut goes all the way on the other goes on behind it then hold second nut &undew the first nut against the second until tight then undew stud with bottom nut)if your lucky u may be able to take the timing case cover off without taking the head off if u use a allow dolly to gentle tap the cover off the locating studs and a paint scaper between the head and timing case to ensure that the head gasket doesnt rip.my usumption is that the motor has not yet started so the head gasket hasnt set yet.
i have done this befor so i know it can be done just be careful
take your time. replacing it is just as hard if your not sure then take the head of
ps when u put the cam chains back on remember to put all the slack on the ajuster side with the timing straight up and down
hope ive helped
|
|
|
