| Author | Topic |
|---|
Location:
newcastle
Registered:
May 2002
|
|
Re: HELP Distributor drive in backwards need ignition
|
Wed, 03 July 2002 15:11
|
 |
the chances of breakage is moderate but i have done this several times with the 2tg for several reasons and once with the 3tgteu so i gess the 18rg would be the same i use a allow dolly 300mm long and 20mm round tap each side once at a time till it comes off gentle is the word dont twist it
although if pulling the motor out is the problem and the motor hasnt started i would just pullthe head off in the car the gasket should be allright if u didnt use any form of gasket gue or hilamar on the head just slide a paint scraper under the head on top of the gasket and work your way along prying the gasket off gentle so as not to tear it the rest of the gaskets bar timing gasketshould be reausable
ps i sent u a pm
|
|
|
