Toymods Car Club Inc: Tech & Conversions => MEGASQUIRT Group Buy happening...

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » MEGASQUIRT Group Buy happening... Show: Today's Posts :: Show Polls Email to friend

Author

Topic

oldcorollas
Forums Junkie

Location:
Kita-Ku, Sapporo, Japan
Registered:
January 2003

Re: MEGASQUIRT Group Buy happening...

Wed, 23 July 2003 11:47

EMP-2TG wrote on Wed, 23 July 2003 21:38

how hard would it be to get a mega squirt runing using 20v quads with ram tubes?
so there would be no map senser?

how does the 20V work out the load? i had thought it was MAP based?

anyways, the MS can be made to run with alpha-N or Map/RPM table. alpha-N is basically for race setups where there is very low MAP signal for most of the rpm range.

there are people successfully running ITB's with the onboard MAP sensor. to even out the pulsing, i've heard ppl take a vac signal from each TB, then join them, and pass into something the size of a fuel filter, then thru a MIG welding tip, both of which are to filter the vac signal and clean it up, so it is steady for the MS.

incidentally, the fuel filter and MIG tip work just like a capacitor/resistor for a frequency filter... hmmm

so basically, just need to tap vac off each TB (between butterfly and motor), smooth the signal (but that may not be needed) and run a single line to the MS.
this help?
Cya, Stewart

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Mon Jan 20 16:55:19 UTC 2025

Total time taken to generate the page: 0.0045680999755859 seconds

.:: Contact :: Home ::.