Toymods Car Club Inc: Tech & Conversions => MEGASQUIRT Group Buy happening...

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » MEGASQUIRT Group Buy happening... Show: Today's Posts :: Show Polls Email to friend

Author

Topic

oldcorollas
Forums Junkie

Location:
Kita-Ku, Sapporo, Japan
Registered:
January 2003

Re: MEGASQUIRT Group Buy happening...

Wed, 23 July 2003 12:30

EMP-2TG wrote on Wed, 23 July 2003 21:38

how hard would it be to get a mega squirt runing using 20v quads with ram tubes?
so there would be no map senser?

ITB's on VW 8V head, has vac line off each TB.
http://www.plasmabunny.com/albums/bodywork/072003_ 005.sized.jpg

also check out this thread"Where to position MAP tap on a system with individual throttle-bodies?"
http://autos.groups.yahoo.com/group/megasquirt/mes sage/26478

from that thread:

Quote:

"Bill, I have logged the signal from each rotor as compared to both tee'd to one line. Individual rotors do not give a clean signal. Both tee'd together are better but not as good as both tee'd through a cheap plastic fuel filter. It's excellent enough that I didn't bother try the MIG/carb jet thing. This is with a 12A with fairly radical intake porting"

btw, that land speed car linked above (hayabusa turbo) has just been dynoed (on an engine dyno) at 619hp@10,000rpm with 30Psi boost, which is not bad for a 1360cc motor.
Very Happy

Cya, Stewart

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Mon Jan 20 16:52:30 UTC 2025

Total time taken to generate the page: 0.0063850879669189 seconds

.:: Contact :: Home ::.