| Author | Topic |
|---|
Location:
Canberra
Registered:
May 2002
|
|
Re: Cressida check engine light on - help
|
Fri, 01 August 2003 10:25
 
|
 |
You need to short two pins on the "Diagnostics" plug under the driver side, Just below the "Bonnet release"...
The pins you need to short are TE1, and E1. Once you do this, turn the ignition key on and the engine light will flash in a sequence as follows...
flash.flash.flash....flash.....
This would be code 3..1 (31)...
If you get this code and post it on the forums, I can probably tell you what may be the problem. However, I have the JZ series engines fault codes, they may be similar and lead you in a constructive direction.
Be careful if you do this, you shouldn't do this if you dont know what you're doing, just wait until you can take it to toyota. I accept no responsibility blah blah. Remember, this works with JZ series engines. Not 100% positive on the 7M series engines. But i'd be confident.
|
|
|
