Toymods Car Club Inc: Tech & Conversions => Strut Brace Spacers

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » Strut Brace Spacers Show: Today's Posts :: Show Polls Email to friend

Author

Topic

freakysoarer
Regular

Location:
QLD
Registered:
March 2003

Re: Strut Brace Spacers

Fri, 22 August 2003 12:13

shinybluesteel wrote on Fri, 22 August 2003 22:00

if i can re-ask the question, why do you need spacers?

there is nothing wrong with using washers, at least nothing more wrong than using any kind of spacer.

unless you have a clearence issue, you would be better off bolting the strut brace hard up agaunst the strut tower top to distrubute the load over a larger area.

if you are wearing out tyres, or your car is tracking funny, then you need an alignment.

the brace needs about an inch to clear the intake manifold.
so no problem using washers?

the car has been 4-wheel aligned by pedders last month...
and yes, alignment is not needed, i checked with pedders.

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Mon Jun 30 09:52:38 UTC 2025

Total time taken to generate the page: 0.0062689781188965 seconds

.:: Contact :: Home ::.