Toymods Car Club Inc: Tech & Conversions => Crossmember/Chassis spacers

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » Crossmember/Chassis spacers Show: Today's Posts :: Show Polls Email to friend

Author

Topic

Stefan
Forums Junkie

Location:
Hobart, Tas
Registered:
May 2002

Re: Crossmember/Chassis spacers	Sun, 24 August 2003 12:28

Umm... I'm confused: if your roll centre is higher than before with these xmemember spacers, and you were going to use RCAs (i assume to compensate lowered for springs), it seems to me you would have to use shorter RCA blocks, not higher ones. Where am I going wrong? Is it because the lowering the xmember also mucks about with the control arm mounts? Also, I thought a higher roll centre was desirable, putting it closer to the front centre of gravity and decreasing front body roll. [Report message to a moderator]

Current Time: Tue Nov 4 00:26:07 UTC 2025

Total time taken to generate the page: 0.0039091110229492 seconds

.:: Contact :: Home ::.