| Author | Topic |
|---|
Toymods Board Member
I supported Toymods
Location:
Turramurra, Sydney.
Registered:
May 2002
|
|
Re: replacing headlining in TA22
|
Mon, 01 September 2003 08:30
 
|
 |
I also replaced mine, I had my mum sew up a nice velour one  , and yeah you gotta remove the windscreens.
Before you put the lining in, go out & spend about $5 on those black springy clips you get from stationery shops, you need about 50 of them, but the smallest cheapest ones are perfect.
Then just use the clips to hold the lining to where it folds under the windscreen seal, have one evry 10cm or so, then just go around & straighten it up one clip at a time. Once it's all perfect give it a trim, so it doesn't come too far past the windscreen seal, otherwise it will act like a wick & draw in any moisture that works its way past your chrome surround, then get some contact adhesive & go around & stick it all down, a small section at a time, replacing all the clips.
Once it's dried for a while (leave the clips on for as long as possible), the winscreen will be easy to install & your roof lining won't wrinkle as it's being installed.
|
|
|
