Toymods Car Club Inc: Tech & Conversions => Help needed with designing...

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » Help needed with designing... Show: Today's Posts :: Show Polls Email to friend

Author

Topic

ed_ma61
Forums Junkie

Location:
Lost in the K hole
Registered:
May 2002

Re: Help needed with designing...

Tue, 16 September 2003 06:12

Steve M wrote on Tue, 16 September 2003 14:48

Bill Sherwood's site has a graph which tells you what intake length is needed for the desired rev range, have a look at the to tell how long to make the induction rams.

intake length, i thought, was caculated from the butterfly of the t/b to the valve face. did not have anything to do with the bellmouth design/length etc... bellmouths are a whole other thing

for bellmouth design, ive got a few links, i just have to dig them up Smile

cheers
ed

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Sat Oct 19 07:27:49 UTC 2024

Total time taken to generate the page: 0.0043389797210693 seconds

.:: Contact :: Home ::.