| Author | Topic |
|---|
Location:
geelong
Registered:
September 2003
|
|
|
| | Subject | Poster | Date |
|---|
 |
Can I Turbo a 20valve
|
20valve69corona | Tue, 30 September 2003 10:36 |
|
Re: Can I Turbo a 20valve
|
suthol | Tue, 30 September 2003 10:45 |
|
Re: Can I Turbo a 20valve
|
toyboy | Tue, 30 September 2003 19:07 |
|
Re: Can I Turbo a 20valve
|
toyboy | Wed, 01 October 2003 17:59 |
|
Re: Can I Turbo a 20valve
|
MR. 2 | Wed, 01 October 2003 22:49 |
|
Re: Can I Turbo a 20valve
|
TE72_Turbo | Thu, 02 October 2003 03:20 |
|
Re: Can I Turbo a 20valve
|
Mr 20Valve | Thu, 02 October 2003 03:59 |
|
Re: Can I Turbo a 20valve
|
TE72_Turbo | Thu, 02 October 2003 04:08 |
|
Re: Can I Turbo a 20valve
|
10sec_rx7 | Thu, 02 October 2003 04:25 |
|
Re: Can I Turbo a 20valve
|
TE72_Turbo | Thu, 02 October 2003 06:37 |
|
Re: Can I Turbo a 20valve
|
Chris Davey | Thu, 02 October 2003 06:00 |
|
Re: Can I Turbo a 20valve
|
toyboy | Tue, 07 October 2003 12:28 |
|
Re: Can I Turbo a 20valve
|
toyboy | Tue, 07 October 2003 12:39 |
Wed, 01 October 2003 17:59
i found on bill sheerwoods page that the 20v and 4agze bottom ends are running the same crank and rods. the block is also of equal strength, the pistons from the ze should be a straight bolt in, and given that the heads are of a non interference type and the pistons aparently dished, there should be no dramas. just watch compression ratios with the different head piston combo. you would be better to run the sivertop 20v as it has closed chamber heads which are less prone to detonation, especialy under boost.you might have to run a copper head gasget of apropriate thickness to get the compression right. or a decompression plate if this wont work. these are suggestions and you should carefully do you own research. 
