Toymods Car Club Inc: Tech & Conversions => 4AGE thematic switch setup question??

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » 4AGE thematic switch setup question?? Show: Today's Posts :: Show Polls Email to friend

Author

Topic

Grega
Forums Junkie

I supported Toymods

Location:
melbourne.victoria.austra...
Registered:
June 2002

Re: 4AGE thematic switch setup question??	Mon, 06 October 2003 08:08

dorikin what switch did u use? u should be able to use a 5 pin relay, one with 87 and 87a i figure. like this +12v to 85 on relay -12v from one side of green sender to 86 on relay. -12v to 30 on relay 87 on relay to ground lead on fan 87a is not connected my understanding is that, when the circuit is normally open ,ie under 80 degrees, 87a will be active and have -12v to it (because 85 and 86 are creating a field holding the switch to 87a) when the field is broken by the circuit closing, 87 should then become active, to which, whatever polarity (being + or -) is held on 30 will be txfrd to the device. i think this is right. someone with more electronics nouse needs to confirm or test to see if this functionality is correct. some good logic is here : http://www.motorsportsdigest.com/perform3.htm more good relay reading here http://www.autoshop101.com/forms/hweb2.pdf i think this is sussed. will try tommorrow. my fucking green switch here at home is broken - and i have two where my car is. sassin frassin. [Updated on: Mon, 06 October 2003 08:13] [Report message to a moderator]

Current Time: Wed Jul 30 03:09:27 UTC 2025

Total time taken to generate the page: 0.0037071704864502 seconds

.:: Contact :: Home ::.