Toymods Car Club Inc: Tech & Conversions => Aftermarket ECU for 4AGE ..Your thoughts

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » Aftermarket ECU for 4AGE ..Your thoughts Show: Today's Posts :: Show Polls Email to friend

Author

Topic

10sec_rx7
Forums Junkie

Location:
Syndey
Registered:
December 2002

Re: Aftermarket ECU for 4AGE ..Your thoughts	Tue, 07 October 2003 04:01

ill answer all your questions for you , a) yes it has a priming pulse, cranking enrichment, after start enrichment, b)yes it has 16 load sites for water temp correction, with interpolation between them, it also has cold accel pump enrichment for crisp throttle transition during warmup C)yes it has a 2 stage accel enrichment, 1 for low rpm and 1 for high rpm, you can adjust the amount of fuel, the time the extra fuel is injected in for, the amount of throttle to trigger it (either in map or tps)and where is turns off, D) yes the microtech has both timing and fuel corrections for water and air temp. A) in matrix mode, you have a full set of 3D maps, which you have a full set of load points every 500rpm, when tuning in this way it fully interpolates between all the load points, basically the same load settings as a e6k haltech, but with BETTER interpolation between the load points. B) the main problem with microtech economy is that people dont bother to set them up, they pay $200 for a dyno tune and they then bag the ecu casue the tuner was careless and never set them up, i have tuned 4ages that get better economy than standard and also WRX's as well, economy tuning is not hard just takes time and thats what people dont pay for when getting a dyno tune done. i will let you know when i fit the LT8 to my misses car, it is totally stock apart from a pod filter, exhuast and 17" wheels, Dale [Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Mon Jul 28 13:12:42 UTC 2025

Total time taken to generate the page: 0.00506591796875 seconds

.:: Contact :: Home ::.