Toymods Car Club Inc: Tech & Conversions => T50 quistion

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » T50 quistion Show: Today's Posts :: Show Polls Email to friend

Author

Topic

TE72_Turbo
Forums Junkie

Location:
Canberra
Registered:
May 2002

Re: T50 quistion	Wed, 29 October 2003 10:58

When I used a T18 (3T-C engine) T50 with a 4A bellhousing, I needed to change the circlip that holds the lay shaft bearing in place (at the front of the box) as it was too wide in outside diameter, and therefore didn't fit into the machined recess in the 4A bellhousing. [Report message to a moderator]

Subject Poster Date

Read Message T50 quistion frozenwarp Tue, 28 October 2003 06:52
Re: T50 quistion FKN16V Tue, 28 October 2003 07:04
Re: T50 quistion TE72_Turbo Tue, 28 October 2003 08:34
Re: T50 quistion THE WITZL Tue, 28 October 2003 08:46
Re: T50 quistion demuire Tue, 28 October 2003 22:22
Read Message Re: T50 quistion CLG Wed, 29 October 2003 00:20
Re: T50 quistion demuire Wed, 29 October 2003 00:44
Re: T50 quistion Byatch Wed, 29 October 2003 00:44
Re: T50 quistion demuire Wed, 29 October 2003 00:46
Re: T50 quistion TE72_Turbo Wed, 29 October 2003 10:58

Previous Topic: Front Mount Intercooler
Next Topic: Is 3 inch Exhaust system too big for 4agze?

Current Time: Tue Aug 5 04:49:39 UTC 2025

Total time taken to generate the page: 0.004080057144165 seconds

.:: Contact :: Home ::.