Toymods Car Club Inc: Tech & Conversions => Upgrade path for 3tgteu

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » Upgrade path for 3tgteu Show: Today's Posts :: Show Polls Email to friend

Author

Topic

CLG
Forums Junkie

I supported Toymods

Location:
Perth, Western Australia
Registered:
December 2002

Re: Upgrade path for 3tgteu	Thu, 06 November 2003 14:36

I cannot explain your 10psi boost level, other than to say your boost guage may be incorrect? On a standard system, you get the same fuel cut (hyperspace to stopped) at 7.3psi, unless disconnected. The computer will keep supplying fuel to increasing levels of boost until the duty cycle of the injectors is reached, which will then allow the engine to run lean and knock computer kicks in to give a big wad of retard to eliminate knocking. The system is not fail safe however and pistons suffering from detonation problems are a common 3TGTE ailment if pushed too far. The computer will regulate the amount of fuel the engine receives regardless of air temp based on the AFM and the oxy sensor in the exhaust. Yes, my setup still runs the standard fuel and knock computers too [Updated on: Thu, 06 November 2003 14:37] [Report message to a moderator]

Current Time: Fri Oct 18 23:30:04 UTC 2024

Total time taken to generate the page: 0.0058951377868652 seconds

.:: Contact :: Home ::.