Toymods Car Club Inc: Tech & Conversions => T50 gearbox noise, need help

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » T50 gearbox noise, need help Show: Today's Posts :: Show Polls Email to friend

Author

Topic

crispy
Occasional Poster

Location:
Christchurch , New Zealand
Registered:
March 2003

Re: T50 gearbox noise, need help	Tue, 18 November 2003 06:47

No you have to buy the spigot bearing seperately, should only cost around $6 or there about. To remove it pack grease behind the bush (into where the input shaft would go). don't get any on the flywheel insert a close fitting bolt to go in the hole and hit the bolt with hammer. Hydraulic pressure will drive it out. This is a bit slow and would recommend being very careful, don't want to have a spigot bearing hit you in the eye or anything. Another way is get a slide hammer pull it out that way. To fit it get an old socket or bit of steel that fits over the outside of the bearing and drive it flush with the crank [Report message to a moderator]

Current Time: Tue Jul 29 07:43:42 UTC 2025

Total time taken to generate the page: 0.0092029571533203 seconds

.:: Contact :: Home ::.