Toymods Car Club Inc: Tech & Conversions => 7M Clutch Queries

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » 7M Clutch Queries - HEEEELLLLLLPPPPPP !!!! Show: Today's Posts :: Show Polls Email to friend

Author

Topic

gianttomato
Forums Junkie

I supported Toymods

Location:
I renounced punctuation
Registered:
May 2002

Re: 7M Clutch Queries - HEEEELLLLLLPPPPPP !!!!	Sun, 14 December 2003 22:27

Well, as you have discovered, there are a range of clutch options. There are the 225mm diameter setups and the 240mm. The 225mm stuff was used on the older SOHC stuff. The later DOHC stuff used the 240mm. The 7MGTE used a 244mm clutch plate from factory with a pull type clutch from factory. Plenty of people have used the smaller diameter 225mm clutch/pressure plates on the 7MGTE with no issues. Of course you need to make sure the pressure plate has a higher clamp pressure (which won't be an issue with the pressure plate you are talking about). However you might find that the 240mm pressure plate comes in an 'off the shelf' heavy duty variety that has as much clamp pressure as the 'race' plate you are looking at for the same price. I'd investigate what's available and costing a little more. [Report message to a moderator]

Current Time: Thu Jul 31 08:46:14 UTC 2025

Total time taken to generate the page: 0.0033450126647949 seconds

.:: Contact :: Home ::.