Toymods Car Club Inc: General Car Talk => Where to start on project car?

Toymods Car Club
www.toymods.org.au

Toymods » General Car Talk » Where to start on project car? Show: Today's Posts :: Show Polls Email to friend

Author

Topic

Grega
Forums Junkie

I supported Toymods

Location:
melbourne.victoria.austra...
Registered:
June 2002

Re: Where to start on project car?	Mon, 22 December 2003 23:25

write down a list of what u're gunna do, and, then priortise it. re: your engine bay, nah, get the engine and fittings and all that shit in there first, get it mounted and working and running, and then take it all out and spray it i sprayed it first, and, putting my 4AGE there are chips and shit all over the shop now (looks ok from a distance, personally i don't give a shit coz its only an engine bay and well it looks 100% better than it did) well you're gunna need a new drive shaft so look at a diff/rear brakes before getting a shaft made, coz if you change your diff your rear uni/length of shaft will change. also forget suspension until u do your diff. don't forget brakes and master/booster too. re: interior depends what u wanna do, but, i'd prolly leave that till last. i have. and by the way be prepared to learn how expensive an engine conversion is. if you reckon you'll get away with it for $2k - think again. [Updated on: Mon, 22 December 2003 23:26] [Report message to a moderator]

Current Time: Mon Jul 28 03:41:35 UTC 2025

Total time taken to generate the page: 0.01133394241333 seconds

.:: Contact :: Home ::.