| Author | Topic |
|---|
Location:
Bundaberg, Qld.
Registered:
May 2002
|
|
Re: modifiying original exhuast manifold
|
Fri, 26 December 2003 23:28
 
|
 |
 the 1st turbo manifold i tried was my old cast exhaust manifold. i cut it where i wanted and got the turbo flange i had cut out of 12mm flat bar brazed onto the cast manifold by a metal engineering shop.
whenever attaching something to cast make sure it's brazed with a oxy set-up. there was no way that my flange was going to crack or fall off. (just a bastard i cut it too low and had oil return problems..  )
you will need a support bracket of some sorts. i made one out of some small square bar, flattened both ends. one end bolts to my block, the other to the turbo flange with the turbo.
|
|
|
| | Subject | Poster | Date |
|---|
 |
modifiying original exhuast manifold
|
haydennz | Fri, 26 December 2003 22:19 |
|
Re: modifiying original exhuast manifold
|
feral4mr2 | Fri, 26 December 2003 23:28 |
|
Re: modifiying original exhuast manifold
|
haydennz | Fri, 26 December 2003 23:46 |
|
Re: modifiying original exhuast manifold
|
feral4mr2 | Sat, 27 December 2003 02:01 |
|
Re: modifiying original exhuast manifold
|
haydennz | Sat, 27 December 2003 02:11 |
|
Re: modifiying original exhuast manifold
|
Allan | Sat, 27 December 2003 02:24 |
|
Re: modifiying original exhuast manifold
|
feral4mr2 | Sat, 27 December 2003 05:51 |
|
Re: modifiying original exhuast manifold
|
oldcorollas | Sat, 27 December 2003 06:57 |
|
Re: modifiying original exhuast manifold
|
TE72_Turbo | Sat, 27 December 2003 03:48 |
|
Re: modifiying original exhuast manifold
|
onejayzed | Mon, 29 December 2003 03:52 |
