Toymods Car Club Inc: Tech & Conversions => removing 1jz hydro water pump

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » removing 1jz hydro water pump Show: Today's Posts :: Show Polls Email to friend

Author

Topic

gianttomato
Forums Junkie

I supported Toymods

Location:
I renounced punctuation
Registered:
May 2002

Re: removing 1jz hydro water pump

Sun, 28 December 2003 11:35

draven wrote on Sun, 28 December 2003 20:46

alrighty, I've removed the pulley, removed the 4 14mm bolts I could see, and it wont come off. I'm guessing you also have to remove the lower timing belt cover to get to a few bolts?

If it is like the 2JZ, you have to loosen the timing belt, and remove the timing belt tensioner too.

draven wrote on Sun, 28 December 2003 20:46

also, what do you guys use to clean the trench in the middle of the head, between the 2 cam covers, that has managed to fill up with all sorts of crap? (to the point where I dont want to pull the sparks in case all that stuff falls into my engine)

Get young Edward to get you some nice 50 mL catheter tip syringes. When the engine is cold, use some turps to wash out the deep valley. Pay particular attention to the recesses where the spark plugs are - all manner of crap lurks there. The syringes can be used to squirt stuff out of there and then you can suck it out. Dry with paper towels or rags.

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Wed Jul 30 10:33:53 UTC 2025

Total time taken to generate the page: 0.0037081241607666 seconds

.:: Contact :: Home ::.