Toymods Car Club Inc: Tech & Conversions => 3k mods, what can I expect to pay

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » 3k mods, what can I expect to pay Show: Today's Posts :: Show Polls Email to friend

Author

Topic

CLG
Forums Junkie

I supported Toymods

Location:
Perth, Western Australia
Registered:
December 2002

Re: 3k mods, what can I expect to pay	Fri, 02 January 2004 13:58

Power output depends on so many factors it would be hard to guess a figure without knowing everything. I recently built a stroked and bored 3K, only to have the owner kill it in under 500KMs through detonation. I was aiming for around 140BHP, but never got the chance to throw it on the dyno for obvious reasons. The build consisted of; clearanced and bored block to suit 4K crank and rods, and Honda pistons, owner's cam of unknown size (a sticking point in thew build, believe me!!!), ported bigport head, 5K head gasket, twin 40mm Webbers and headers, electronic ignition, ... I still have a brand new inlet manifold to suit twin Webbers if you decide to change the induction too?!? [Report message to a moderator]

Current Time: Sat Jul 26 07:08:09 UTC 2025

Total time taken to generate the page: 0.0060040950775146 seconds

.:: Contact :: Home ::.