| Author | Topic |
|---|
Toymods Board Member
I supported Toymods
Location:
Turramurra, Sydney.
Registered:
May 2002
|
|
Re: Cressida tail shafts
|
Wed, 07 January 2004 13:44
 
|
 |
Doh, 6 bolt hey, that sux.
The yokes have the same o.d., but the old is 21 spline & the new 23.
Yeah 600 was the mentioned price, and that included changine the flange on the diff to bolt up to a bigger tailshaft flange that takes a bigger uni, & pulling out & stuffing around with the diff is goona add more onto that, & it's just too close too 1000 bucks.
I think attaching the new yoke to old shaft will be the go, & when or if the tiny cressida unis go I'll look at what can be done.
I think half the trouble is that the new yoke has been cut short, so there's not much to weld to, plus it's very close to the uni, which feels a bit old anyway, but is staked into place.
I might see if SSS have any others that havn't been cut so close.
|
|
|
| | Subject | Poster | Date |
|---|
 |
Cressida tail shafts
|
BigWorm | Wed, 07 January 2004 10:38 |
|
Re: Cressida tail shafts
|
CrUZsida | Wed, 07 January 2004 13:14 |
|
Re: Cressida tail shafts
|
Darren | Wed, 07 January 2004 21:48 |
|
Re: Cressida tail shafts
|
gianttomato | Wed, 07 January 2004 23:34 |
|
Re: Cressida tail shafts
|
BigWorm | Wed, 07 January 2004 13:44 |
|
Re: Cressida tail shafts
|
CrUZsida | Wed, 07 January 2004 13:56 |
|
Re: Cressida tail shafts
|
BigWorm | Wed, 07 January 2004 23:54 |
|
Re: Cressida tail shafts
|
CrUZsida | Thu, 08 January 2004 00:30 |
|
Re: Cressida tail shafts
|
justcallmefrank | Thu, 08 January 2004 00:34 |
|
Re: Cressida tail shafts
|
draven | Thu, 08 January 2004 01:33 |
|
Re: Cressida tail shafts
|
CrUZsida | Thu, 08 January 2004 01:36 |
|
Re: Cressida tail shafts
|
BigWorm | Thu, 08 January 2004 14:00 |
|
Re: Cressida tail shafts
|
Allan | Thu, 08 January 2004 15:23 |
|
Re: Cressida tail shafts
|
BigWorm | Thu, 08 January 2004 15:40 |
|
Re: Cressida tail shafts
|
BigWorm | Fri, 09 January 2004 16:01 |
