Toymods Car Club
www.toymods.org.au
F.A.Q. F.A.Q.    Register Register    Login Login    Home Home
Members Members    Search Search
Toymods » Tech & Conversions » draining/flushing auto fluid

Show: Today's Posts  :: Show Polls 
Email to friend 
Return to the default flat view Create a new topic Submit Reply
AuthorTopic
clubagreenie
Forums Junkie


Location:
1st street on the right
Registered:
November 2002
 
Re: draining/flushing auto fluid Sun, 18 January 2004 07:33 Go to previous messageGo to previous message
It will kind of mix with the auto fluid, making it pinkish. There was another thread here by memory detailing how to do this.

This is from planet soarer.

"FLUSHING THE OLD FLUID
Regardless of the type of ATF a transmission requires, it?s important to replace as much of the old fluid as possible when servicing the fluid and filter. Some flushing machines connect to the ATF cooler lines to simultaneously drain the old fluid while adding fresh fluid. This is done while the engine is idling and fluid is circulating through the cooler lines. With this type of equipment, various adapters are required to make the connections. Some units have a booster pump to speed up the process on vehicles where ATF flow is slow (some Asian transmissions). This type of flushing procedure does not require dropping the pan or replacing the filter, but a filter replacement is recommended and should be done after flushing (fresh fluid from the pan can be recovered and put back into the transmission after the filter has been replaced to eliminate waste.)


You can flush the fluid yourself at home without any fancy equipment. I just flushed a ZF 4 speed trans - same principles apply. Undo the top oil cooler line going into the radiator. Put a large diameter clear plastic hose over the brass thread on the radiator. Place the end of the hose into a container. Start the car for 2-4 secs and observe the oil going through the hose. Mine started out looking like mud. Turn car off. Place funnel in dipstick and refill trans with fresh oil. Start car again for 2-4 secs and watch the fluid again. I used a graduated clear plastic bottle  - I knew how much oil was coming out - so I knew how much oil to put back in. When the oil started to look clear and red then I was done - took 12 litres of fluid to get it to this stage. Reassemble the oil cooler line, check level - go for a drive - check level again. Capacity is about 8 litres. Draining the pan or sucking it out the dipstick I could only get 2 litres out at a time no matter what I did. "

At http://planetsoarer.com/autotrans/autotrans.htm


Alternately you may be able to suck it through the filler tube.
  Send a private message to this user    

SubjectPosterDate
Read Message   draining/flushing auto fluid chrisssSun, 18 January 2004 04:53
Read Message   Re: draining/flushing auto fluid thechucksterSun, 18 January 2004 05:20
Read Message   Re: draining/flushing auto fluid  clubagreenieSun, 18 January 2004 07:33
Read Message   Re: draining/flushing auto fluid people100Sun, 18 January 2004 09:02
Previous Topic:Do I have TEMS?
Next Topic:how to hook up air/fuel gauge on 7mgte?

Goto Forum:
-=] Back to Top [=-

Current Time: Tue Feb 4 01:02:18 UTC 2025

Total time taken to generate the page: 0.0070319175720215 seconds

Bandwidth utilization bar

.:: Contact :: Home ::.

Powered by: FUDforum 2.3.8
Copyright ©2001-2003 Advanced Internet Designs Inc.