| Author | Topic |
|---|
I supported Toymods
Location:
Perth, Western Australia
Registered:
December 2002
|
|
Re: 3TGTE potential purchase...... what should i ask?
|
Sat, 24 January 2004 07:11
|
 |
|
You can't compression test a motor by spinning it by hand, if it's not in a half cut (and I doubt it will be), you'll have to use a battery and the starter motor circuitry to spin it over. Yes, cold and hot compressions will vary, however the finally number will still be indicitive of the condition of the engine. I have quoted cold compression numbers above.
|
|
|
| | Subject | Poster | Date |
|---|
 |
3TGTE potential purchase...... what should i ask?
|
boris | Thu, 22 January 2004 08:38 |
|
Re: 3TGTE potential purchase...... what should i ask?
|
CLG | Thu, 22 January 2004 14:11 |
|
Re: 3TGTE potential purchase...... what should i ask?
|
boris | Fri, 23 January 2004 03:48 |
|
Re: 3TGTE potential purchase...... what should i ask?
|
ThatDogsFullySickMate | Fri, 23 January 2004 10:08 |
|
Re: 3TGTE potential purchase...... what should i ask?
|
boris | Fri, 23 January 2004 10:54 |
|
Re: 3TGTE potential purchase...... what should i ask?
|
ThatDogsFullySickMate | Fri, 23 January 2004 11:37 |
|
Re: 3TGTE potential purchase...... what should i ask?
|
boris | Fri, 23 January 2004 11:48 |
|
Re: 3TGTE potential purchase...... what should i ask?
|
ThatDogsFullySickMate | Fri, 23 January 2004 12:04 |
|
Re: 3TGTE potential purchase...... what should i ask?
|
boris | Fri, 23 January 2004 12:11 |
|
Re: 3TGTE potential purchase...... what should i ask?
|
ThatDogsFullySickMate | Fri, 23 January 2004 12:40 |
|
Re: 3TGTE potential purchase...... what should i ask?
|
boris | Sat, 24 January 2004 05:01 |
|
Re: 3TGTE potential purchase...... what should i ask?
|
CLG | Sat, 24 January 2004 07:11 |
