Toymods Car Club Inc: Miscellaneous => NISSIAN 300ZX MAGS Z WHEELS 16INCH

Toymods Car Club
www.toymods.org.au

Classifieds » Miscellaneous » NISSIAN 300ZX MAGS Z WHEELS 16INCH Show: Today's Posts :: Show Polls Email to friend

Author

Topic

TheGecko
Occasional Poster

Location:
Brisbane
Registered:
September 2003

Re: NISSIAN 300ZX MAGS Z WHEELS 16INCH	Thu, 29 January 2004 09:55

The scary part is, the little profile panel on the left says 'anthony84' is a regular poster 225/50/16 is the tyre size not the wheel size. A 225 tyre could be fitted to quite a few different rim widths ie wedged onto a 7" rim or stretched out onto a 9" or even 10" for that crazy 'dorifto' look. The wheel cannot be 25mm wide unless it is off a 50cc moped and even then it'd be more like 50mm+. If you actually mean 250mm then that's 10" which is pretty wide for a factory stock wheel. So, either find the cast or stamped numbers on the rim (not the tyre, the rim) that say something like 16JJ8 or JJ7 or whatever or, just measure the actual width of the rim. To do this, put something flat across the rim beads (the edges of the rim where the tyre seats. On the rim, not on the sidewalls of the tyre) on the outside face and measure down to the bottom of a stud hole. Then do the same on the inside (back) face of the rim and measure to the flat bolting up face (which is also where the bottom of that stud hole is). Then just tell us those two numbers. That way, people who can do maths can work out the width and the offset too. Hope this helps. If people here keep asking you for more info, it probably means you're not supplying it. [Report message to a moderator]

Current Time: Mon Jul 28 12:23:52 UTC 2025

Total time taken to generate the page: 0.004101037979126 seconds

.:: Contact :: Home ::.