JE forgies + 205 rods + ARP rod bolts , Arp head studs too
Thats the basis of the engine ..
Gasket wise i think ill go a TRD item at this stage - Cheap thru penrith toyota with the toymods discount ..
bearings i was told cant be bought off shelf until they have been removed to see what ones are required to fit the motor.
The pistons are a wee bit oversize so a Hone is in order - and the head will be de-dagged - but not ported out or polished up to any great extent - it doesnt need it ..
Im aiming to run 18 - 20PSI thru it at this stage .
Still need to know things like leads - whats a good setup to use there + cams if i go to that extent ..
Rings - ill probably see about chromoly ones to match the pistons
Thu, 12 February 2004 03:00
