| Author | Topic |
|---|
Location:
Adelaide
Registered:
May 2002
|
|
Re: 4AG to W5* using the original W bellhousing
|
Sun, 29 February 2004 07:13
 
|
 |
Hi Mrsbitch,
I'm doing the same thing but mine is a 4AGTE to W50 using the W50 bellhousing. Basically this is because i want to use the 4AGZE clutch and it wont fit in the Dellow or T50 bellhousing not to mention a much stronger/reliable driveline.
I havent done it yet, but i do have some good information from someone who has done this exact conversion.
The input shaft is different. The W50 is much fatter but the spline is the same size as the 4AGZE clutch plate and apparently the 4AG spigot bearing is the same. Cant say i tried the T50 spline on the 4AGZE clutch plate but i think it is smaller.
The method of location is via a 10 - 12mm plate which bolts to the 4A block then the W50 bolts to the plate. Some points may require either a stud to be used or a thread cut into the plate.
5mm is shaved from the front of the W50 Bellhousing. This combined with the slightly taller 4AGZE flywheel helps to put the clutch fork' throw where it needs to be.
This is a rough overview. I havent done mine yet so i dont know if there are any intricate little problems. The info i have i got from a fella on Toymods called TA22-3SGTE he's done it and gives it two thumbs up. So he might be able to help you with more detail.
Rex
|
|
|
