| Author | Topic |
|---|
Location:
Newcastle
Registered:
April 2003
|
|
Re: M electronic ignition conv
|
Wed, 10 March 2004 08:53
 
|
 |
This is dead easy to do the job.
Get the 5M dist and plate (goes under dist) bolt the plate to the block once you have removed the old dist.Fit the elec dist and bolt that to the plate.
Then undo your old coil and put it aside (make sure you remember which wire went where) and install 5M coil and igniter.Hook up the wires to where they need to go and plug the dist into the coil.
Everthing being done right it should fire into life no worries,i have done this to the early 4M motor so a late one should be a breeze.
As for the price it sounds a bit over the top to me as they are not something you would sell at the wreckers cause the bloody things never stuff up.
Hope this helps.
|
|
|
