| Author | Topic |
|---|
Location:
Sydney
Registered:
April 2003
|
|
Cutting hole in bonnet for a bonnet scoop
|
Thu, 25 March 2004 06:56
|
 |
Need your advice everyone.
Trying to mount a bonnet scoop in the centre of my bonnet and wanting to cut a hole in the centre. However there is a bonnet support straight through the centre. What if I just cut the bonnet metal without cutting the bonnet support? I am looking at getting this engineered.
I asked an engineer today - if the bonnet supports are cut then it cannot be engineered. But if I cut just the bonnet metal on either side of the bonnet support (i.e instead of having one big square I have two smaller squares on both sides of the bonnet support) for a hole and not cut any supports it can be engineered but the bonnet needs to be reinforced.
Anyone got any ideas on how to reinforce the bonnet?
Cheers
|
|
|
