| Author | Topic |
|---|
Location:
Kita-Ku, Sapporo, Japan
Registered:
January 2003
|
|
Re: Complete EFi setup for 4K engine.
|
Fri, 02 April 2004 13:13
|
 |
fwiw, complete setups are difficult to come by and not really what you need...
4KE, 145cc/min injectors, AFM, 40mm TB, etc etc.. the ECU is old, basically same as early 2TG ones, and you will need the original sensors to work with the ECU..
a 4KE setup including manifold, runners, plenum, throttle body, injectors, fuel rail, ROCKER COVER (you NEED this as the runners go over the top of it), and electronic dizzy, would be around $300-350.. the dizzy itself is worth around $100...
7KE, like the one on ebay, is prolly worth $300-350 also, but without the elec dizzy and rocker cover etc...
there are some available in NZ, i can sometimes get them from the US for about US$200 + shipping and duty/GST
a stock 4KE is nice to drive... drove a starlet in the US  ..
for bigger cam, or revs higher than about 6000, you'll need bigger injectors.. about 180cc/min should be fine for up to 8000 on a 1.3.....
you would be better off using a programmable ECU, and hopefully i can do some back to back tests to see if the long 4KE, or short 7KE runners work best in modded motor...
Cya, Stewart
|
|
|
