| Author | Topic |
|---|
Location:
Brisbane
Registered:
October 2002
|
|
Re: 18RG rebuild
|
Sat, 03 April 2004 07:29
 
|
 |
depending on the engineering shop where u get your gasket kit, they can charge u up to $300 for a kit, or as low as $170
bearings
main: $50
bigend: $50
rings: $50
machining
depends on what u need, if u need just a hone, then just the cost of a hone down at autobarn
full recondition of the head including setting the shims is about $400-500
if u need pistons then u r up for a bit, cause u cant get them new off the shelf, u r best getting a set of hi-comp ones off the for sale section here,
anything more, just ask
|
|
|
| | Subject | Poster | Date |
|---|
 |
18RG rebuild
|
Dood | Sat, 03 April 2004 04:14 |
|
Re: 18RG rebuild
|
Mr DOHC | Sat, 03 April 2004 07:29 |
|
Re: 18RG rebuild
|
SeptemberSquallIndustries | Sat, 03 April 2004 07:44 |
|
Re: 18RG rebuild
|
Mr DOHC | Sat, 03 April 2004 07:49 |
|
Re: 18RG rebuild
|
Dood | Sat, 03 April 2004 08:03 |
|
Re: 18RG rebuild
|
CelicaRA45 | Sun, 04 April 2004 09:30 |
|
Re: 18RG rebuild
|
CelicaRA45 | Sun, 04 April 2004 09:31 |
|
Re: 18RG rebuild
|
sik sx | Sun, 04 April 2004 11:29 |
|
Re: 18RG rebuild
|
bbaacchhyy | Mon, 05 April 2004 02:51 |
|
Re: 18RG rebuild
|
Mr DOHC | Mon, 05 April 2004 07:19 |
|
Re: 18RG rebuild
|
sik sx | Mon, 05 April 2004 12:00 |
|
Re: 18RG rebuild
|
Mr DOHC | Tue, 06 April 2004 08:07 |
