| Author | Topic |
|---|
I supported Toymods
Location:
Perth, Western Australia
Registered:
December 2002
|
|
Re: Moving Stripped Cars Around
|
Thu, 22 April 2004 04:33
 
|
 |
If you don't have a welder, look at having a rectangular frame made up. I've always used the two front engine cross member points, and the two rear lower control arm points to determine the frame size - simply use a plumb to mark it on the ground to get your measurements. Then it's simply a matter of getting the castors welded on one side, and risers to the height you want on the other. The top end of the rear risers can then have a hole drilled in them to take the original lower controll arm bolt, while the fronts will need a flat bar section with matching engine cross member holes to bolt too, also.
Clint
|
|
|
| | Subject | Poster | Date |
|---|
 |
Moving Stripped Cars Around
|
dcleyne | Wed, 21 April 2004 05:22 |
|
Re: Moving Stripped Cars Around
|
Lambolica | Wed, 21 April 2004 05:25 |
|
Re: Moving Stripped Cars Around
|
CLG | Wed, 21 April 2004 05:29 |
|
Re: Moving Stripped Cars Around
|
gianttomato | Wed, 21 April 2004 05:34 |
|
Re: Moving Stripped Cars Around
|
Disco Scoob | Wed, 21 April 2004 05:41 |
|
Re: Moving Stripped Cars Around
|
dcleyne | Wed, 21 April 2004 06:00 |
|
Re: Moving Stripped Cars Around
|
mrshin | Wed, 21 April 2004 12:59 |
|
Re: Moving Stripped Cars Around
|
gianttomato | Wed, 21 April 2004 13:01 |
|
Re: Moving Stripped Cars Around
|
thechuckster | Wed, 21 April 2004 13:33 |
|
Re: Moving Stripped Cars Around
|
dcleyne | Thu, 22 April 2004 00:43 |
|
Re: Moving Stripped Cars Around
|
CLG | Thu, 22 April 2004 04:33 |
|
Re: Moving Stripped Cars Around
|
3T-GTE | Thu, 22 April 2004 05:03 |
|
Re: Moving Stripped Cars Around
|
dcleyne | Fri, 23 April 2004 02:16 |
|
Re: Moving Stripped Cars Around
|
dcleyne | Sun, 02 May 2004 03:06 |
|
Re: Moving Stripped Cars Around
|
ed_ma61 | Sun, 02 May 2004 04:20 |
|
Re: Moving Stripped Cars Around
|
dcleyne | Sun, 02 May 2004 05:11 |
|
Re: Moving Stripped Cars Around
|
dcleyne | Sun, 02 May 2004 05:52 |
|
Re: Moving Stripped Cars Around
|
3T-GTE | Mon, 03 May 2004 00:31 |
